Cfesa Refrigeration Practice Test Official

A reach-in freezer with hot gas defrost has frost only on the last pass of the evaporator. This indicates: a) Undercharge of refrigerant b) Defrost termination failed open c) TXV stuck open d) Non-condensables in the system

The primary purpose of the accumulator is to: a) Store liquid refrigerant b) Prevent liquid slugging to the compressor c) Filter debris from oil d) Increase subcooling Section 2: Electrical & Controls 4. A potential relay is commonly used with which type of compressor motor? a) PSC b) CSIR c) CSCR d) Shaded pole cfesa refrigeration practice test

A compressor draws locked rotor amps immediately on start and trips the internal overload. The first step is: a) Replace the compressor b) Check for electrical short to ground c) Check for mechanical seizure d) Measure start capacitor microfarads Section 4: Commercial Refrigeration Specifics 10. In a multiple-evaporator supermarket rack system, oil return to the compressor is maintained by: a) Oil separators and timed oil return valves b) High hot gas pressure c) Continuous compressor operation d) Low superheat settings A reach-in freezer with hot gas defrost has

A defrost termination thermostat is wired in series with the: a) Evaporator fans b) Compressor contactor coil c) Defrost heater d) Liquid line solenoid Section 3: Troubleshooting & Diagnostics 7. A walk-in cooler has low suction pressure, low superheat, and a starved evaporator. The most likely cause is: a) Overcharge of refrigerant b) Liquid line restriction c) Bad compressor valves d) High evaporator fan speed a) PSC b) CSIR c) CSCR d) Shaded