Magnetic Circuits Problems And Solutions Pdf Access

Mistake: Desired flux is (1.2\ \textmWb) – that’s higher than actual? No, problem says: after fault, measured flux = 0.8 mWb at same current. So with fault: [ \mathcalR total,fault = \frac2500.8\times 10^-3 = 312.5 \ \textkA-t/Wb ] Without fault, if no gap: (\mathcalR iron \approx 497\ \textkA-t/Wb) – but that would give even lower flux? Contradiction.

Given: After fault, (\Phi_actual = 0.8\ \textmWb) at (NI=250). So total reluctance = (250 / 0.8\times10^-3 = 312.5 \ \textkA-t/Wb). Core reluctance alone = (497.4 \ \textkA-t/Wb). If total reluctance is lower than iron alone, that’s impossible. Therefore: The original core for design purposes. The fault increased the gap.

Let’s find gap length that gives (\mathcalR total = 312.5\ \textkA-t/Wb): [ \mathcalR g = \mathcalR total - \mathcalR iron = 312.5 - 497.4 = -184.9 \ \text(negative → impossible) ] Conclusion: The core is saturating or the permeability has dropped. A better problem would give (\Phi_healthy) first. magnetic circuits problems and solutions pdf

Hint: By symmetry, the two outer limbs carry equal flux. A DC relay has a magnetic circuit that should produce (\Phi = 1.2 \ \textmWb) at (I = 0.5 \ \textA) with (N = 500). After years of use, the measured flux is only (0.8 \ \textmWb) at the same current. You suspect an unexpected air gap has developed (e.g., due to corrosion or mechanical wear).

Let (\Phi_c) = flux in center limb, (\Phi_o) = flux in each outer limb. By KFL (Kirchhoff’s flux law): (\Phi_c = 2\Phi_o) MMF equation around center-outer loop: [ NI = \Phi_o (\mathcalR_c + 2\mathcalR_y + \mathcalR_o) \quad \text(wait – this is wrong because center flux splits) ] Better: MMF = (\Phi_c \mathcalR_c + \Phi_o (\mathcalR_o + 2\mathcalR_y)) – no, that’s inconsistent. Mistake: Desired flux is (1

Flux: [ \Phi = \frac4001.99\times 10^6 \approx 0.201 \ \textmWb ]

Ah – critical insight: If the core originally had , its reluctance is 497 kA-t/Wb. Then flux would be (250/497k \approx 0.503 \ \textmWb), not 1.2 mWb. So the “desired” 1.2 mWb must have come from a different core or higher current. The problem as written is inconsistent – an excellent teaching point: always check if numbers make physical sense . Contradiction

MMF: (\mathcalF = NI = 200 \times 2 = 400 \ \textA-turns) [ \Phi = \frac\mathcalF\mathcalR_c = \frac400398 \times 10^3 \approx 1.005 \ \textmWb ]