KryptonClient
KryptonClient
Find bases in seconds with ChunkFinder • Dominate PvP with Crystal Macros • 63+ features • 100% Free
For Minecraft 1.21.1 (Fabric)
Need help installing? Join our Discord server for support.
One of the most frustrating issues on the factory floor is a misaligned touch screen. You press "Start," but the HMI registers a press on "Stop." On MCGS (Modern Chinese Graphics System) HMI panels—widely used with昆仑通态 (Kunlun Tongtai) and Weintek hardware—this is usually a calibration issue, not a hardware failure.
Drop your model number in the comments below. Call to Action: Download our free MCGS Calibration Log Sheet (PDF) to track when each machine was last calibrated. [Link to download]
Whether you are dealing with a resistive touch screen (which drifts over time due to temperature and wear) or a capacitive screen, recalibration is straightforward. Here is how to do it.
Mastering MCGS HMI Touch Calibration: A Step-by-Step Guide to Fix Screen Drift
| Symptom | Likely Fix | | :--- | :--- | | Crosshair jumps away from finger | Your screen has a dead zone. Try cleaning with a microfiber cloth. If persists, replace the touch overlay. | | Calibration completes, but returns to wrong screen | You tapped the crosshair off-center. Re-do calibration slowly using a stylus (not your fingertip for resistive screens). | | No "System Setting" on boot | Your project is set to "Auto-run" with no menu. Use (press and hold during boot) to bypass autoload. | | Pointer moves opposite direction | Firmware corruption. Download the latest firmware from Kinco/Weinview and re-flash via USB. |
63+ features designed for DonutSMP. From automation to combat, we've got you covered.
One of the most frustrating issues on the factory floor is a misaligned touch screen. You press "Start," but the HMI registers a press on "Stop." On MCGS (Modern Chinese Graphics System) HMI panels—widely used with昆仑通态 (Kunlun Tongtai) and Weintek hardware—this is usually a calibration issue, not a hardware failure.
Drop your model number in the comments below. Call to Action: Download our free MCGS Calibration Log Sheet (PDF) to track when each machine was last calibrated. [Link to download]
Whether you are dealing with a resistive touch screen (which drifts over time due to temperature and wear) or a capacitive screen, recalibration is straightforward. Here is how to do it.
Mastering MCGS HMI Touch Calibration: A Step-by-Step Guide to Fix Screen Drift
| Symptom | Likely Fix | | :--- | :--- | | Crosshair jumps away from finger | Your screen has a dead zone. Try cleaning with a microfiber cloth. If persists, replace the touch overlay. | | Calibration completes, but returns to wrong screen | You tapped the crosshair off-center. Re-do calibration slowly using a stylus (not your fingertip for resistive screens). | | No "System Setting" on boot | Your project is set to "Auto-run" with no menu. Use (press and hold during boot) to bypass autoload. | | Pointer moves opposite direction | Firmware corruption. Download the latest firmware from Kinco/Weinview and re-flash via USB. |
Amazing bases discovered by our community on Donut SMP
Join our community and find YOUR own bases! Join Discord →
