New- Hints And Kinks For The Radio Amateur Apr 2026

Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles).

Before snapping the bead onto the cable, wrap the coax with one layer of friction tape (cloth electrical tape) or two wraps of vinyl electrical tape where the bead will sit. Then push the bead over the taped section.

Tried-and-true tricks, fresh twists, and shop-tested solutions for the modern shack New- Hints and Kinks for the Radio Amateur

Loosen the element set screw. Slide the element until it touches the clamp. Tighten. Check SWR. Move clamp up or down by measured inches. No more lowering the mast 15 times. 6. Cleaning Potentiometers Without Deoxit (Field Hack) The problem: Scratchy volume or tone control on your vintage receiver, and you’re out of contact cleaner.

Use vulcanizing silicone tape (often sold as "rescue tape" or "self-fusing silicone tape"). It’s about $8–10 per roll. Stretch it 100% as you wrap—it fuses to itself into a solid rubber sleeve. Not always, but in a pinch, stranded 18-gauge

Stick a metal ruler (12" or 24") directly to the fiberglass or wooden mast using double-sided foam tape, aligned vertically with the antenna element. Use a small spring clamp or a plastic clothespin on the ruler as a temporary stop.

By WB2FAS (In the spirit of the original QST column) The "Eyeglass" SMA Wrench (Free & Perfect) The

Remove the knob. Drip 2–3 drops of isopropyl alcohol (91% or higher) into the shaft opening. Rotate the pot back and forth fully 20–30 times. Let it dry 5 minutes. Then add one tiny drop of lightweight machine oil (sewing machine oil or even 3-in-1) to the same spot. Rotate again 10 times.

This is for RF ground and equipment bonding , not for lightning or AC safety ground. Always keep your AC safety ground separate and intact. 8. Silicone Baking Mat = Portable Work Surface The problem: Tiny screws, washers, and springs roll off your bench and into the abyss (also known as the carpet).